WSEAS Transactions on Environment and Development
Print ISSN: 1790-5079, E-ISSN: 2224-3496
Volume 16, 2020
(This paper belongs to the Special Issue "Advanced Materials") Incorporation of Phase Change Materials in Lightweight Aggregate Concrete
Authors: , , , ,
Abstract: An investigation on some methods for the incorporation of phase change materials (PCMs) into concrete and their effect on its properties is presented. PCMs are characterized by high latent fusion heat, which can increase thermal mass of concrete and contribute to the bioclimatic design of buildings. Concrete compositions with different aggregates (limestone, lightweight or their combination), as well as with different PCMs (paraffinic and dodecyl alcohol) were prepared by different incorporation methods (impregnation to lightweight aggregates or immersion of concrete specimens). Properties of fresh and hardened concrete were studied, as well as hydration heat, thermal response and flammability. The results revealed that the selected PCMs do not significantly affect the properties of concrete. Regarding hydration heat, the presence of the PCM in concrete contributes to a decrease of the temperature peak during hydration which also occurs delayed. Thermal response measurements showed that concrete with purely pumice aggregates has a much better thermal behavior than the other two compositions, while the existence of PCM causes large or small increase of concretes heat capacity, in temperature near to each PCM’s melting point. Finally, appropriate application of PCMs is needed in order to moderate the reported effect on concrete’s fire resistance
Search Articles
Keywords: Concrete, Lightweight Concrete, Phase Change Material (PCM), Hydration Heat, Thermal Response, Flammability
Pages: 105-118
DOI: 10.37394/232015.2020.16.11